Haws 8317 Bedienungsanleitung PDF herunterladen (Seite 3)

12/12 Model 8317 Page 3 of 5

TROUBLESHOOTING

PROBLEM

REPAIR CHECKLIST

1. No flow. 1. Check the main shut-off valve.

2. Insufficient water flow, shower and

eyewash.

2. Verify minimum 30 psi (2 ATM)

flowing supply line pressure.

3. Insufficient water flow on eye/face

wash, however, shower is

sufficient.

3. a. Verify minimum 30 psi (2 ATM)

flowing supply line pressure.

b. Probable clogging of flow control

due to inadequate line flushing.

Unscrew eye/face wash head and

remove the four screws to

disassemble the head. Clean flow

control and reassemble head. See

SP65 Installation Drawing for

details.

4. Eye/face wash stream does not

meet desired eye level.

4. a. Possible blocked flow control, see

above solution.

b. Possible non-leveled eye/face wash

assembly.

5. Insufficient water flow at the

showerhead, however, eye/face

wash is sufficient.

5. Probable clogging of flow control

inside shower head. Unscrew

shower head off of elbow and clean

rubber flow control.

6. Water does not drain properly. 6. Check your drain system for debris.

Check the main waste line of your

building to see if it does handle the

capacity required for the entire

drainage system.

7. Water leak between joints or

fittings.

7. Tighten loose connections. If leak

persists, the application of hot water

will sometimes reseat improperly

applied joint compound. After 30

minutes wait and retest, a persistent

leak will necessitate reassembly and

additional sealant.

For more information on Haws Products, please see our website: www.hawsco.com

HAWS

and other trademarks used

in these materials are the exclusive property of Haws Corporation.

1 2 3 4 5

Kommentare zu diesen Handbüchern

Keine Kommentare

Haws 8317 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheit Haws 8317